The selection of the machine-made sand site has a very important impact on the future operation of the entire sand and gravel plant. A suitable site can not only ensure stable production, but also greatly improve production efficiency and even save production costs. Therefore, it is necessary to investigate the surrounding environment before opening a sand and gravel plant to ensure that the site selection can achieve greater satisfaction. Specifically:
1. Convenient road traffic conditions, convenient electricity and water use.
Nowadays, many sand and gravel plants still use fixed production lines, so aggregate transportation is particularly important. The sand production line involves sand washing, sedimentation, fine sand recovery and other links. Therefore, the water resources near the site must be abundant and sufficient conditions to build a sedimentation tank treat sewage, etc.
2. Keep away from residential areas, and in order to reduce pollution, it is advisable to choose the downwind outlet with the dominant wind.
All aspects of the production of machine-made sand will inevitably produce certain noise and dust. Therefore, generally sand and gravel plants are built far away from residential areas. Choose the downwind outlet that dominates the wind to avoid certain pollution.
3. The area of the factory, and the storage yard and capacity of raw materials and finished materials.
Due to environmental restrictions, many sand and gravel plants cannot operate in the open air and need to build workshops. Therefore, the area of the plant must be as large as possible, because it not only requires turnover of all links in sand making, but also the stacking of raw materials, intermediate materials and finished materials. A certain amount of space is required for accumulation.
4. The site should have good engineering geological conditions: the site should avoid construction under faults, landslides, and flood levels, and should avoid silt, humus, ancient wells and other bad sections or cultural relic protection.
Basic sand making production line: vibrating feeder-jaw crusher-vibrating screen-impact crusher / cone crusher-circular vibrating screen-vertical impact sand making machine-sand washing machine-finished product. This is basically complete sand making production line, but not all the equipment in it is used in all situations, such as pebbles/river pebbles. If the raw materials are small enough, the previous coarse crushing equipment can be omitted appropriately. The reason why the front end is equipped with crushing equipment is to crush the raw stone to the size of the sand making machine. The inlet of the sand making machine is generally below 5 cm. Of course, if the size of the raw stone itself is less than 5 cm, then the previous crushing equipment it can be completely omitted.
Secondly, in addition to understanding the basic sand production line, special attention should also be paid when purchasing equipment. Special attention should also be paid to the selection of manufacturers. In addition to guaranteeing the quality of the equipment, the big brand manufacturers also have the person in charge of the technology to design an environmentally friendly sand production line according to the specific situation. Provide convenience for handling environmental assessment procedures. Therefore, when purchasing equipment, try to choose large manufacturers, let them provide them with configuration plans, etc., and then make a decision after multi-directional comparison.
Of course, if you just want to invest money and leave all related matters to the relevant professional person in charge that is the EPC general contracting service? You only need to pay for the investment, from the initial plant site selection to the production line operation to the equipment maintenance within the EPC package. Luoyang Dahua Heavy Industry Factory has focused on the research and development and manufacturing of crusher equipment for more than ten years, and one-stop solution for you to solve the problems related to equipment selection, configuration and production line process design. You are welcome to consult online or call, and we have dedicated technical staff to answer your questions! You are also welcome to visit the factory for consultation, or visit the production line site!