How to solve overheated problem for gyratory crusher oil?
The gyratory crusher is mainly for middle hardness stone. How to solve overheated problem for gyratory crusher oil?
1. Check the tube switch if cooling water has problem. Check if any switch no open or jam. Clean jam tube and make sure if any defect of water pump and motor.
2. Usually the crusher working situation is full of powder. The powder is easy to enter and make oil rise. Solution: check the sample and if any rub oil defect. Change the lub oil in time.
3. Oil pump wearing bad can also make oil pressure low. If any wearing of gear, it cause the low oil pressure and high oil temperature. If in this case, change oil pump.
4.Oil is not enough and if the pipe flange leak, the solution is: flange bolt loosening caused by vibration and the oil, tighten bolts or replacement; Because do not pay attention to in the installation process, wounded tubing flange sealing ring, sealing ring is replaced. If the oil pipe leakage, the solution is: according to the damage of the tubing, Replace the tubing or with electric welding repair welding, and then add the protection on this section of the tubing flap. If the eccentric sleeve, the gap between central dust cover snap ring is not adjusted, the solution is: When installing a eccentric sleeve, eccentric sleeve should be adjusted at the bottom of the pad iron, check the size of the eccentric sleeve between the top and the bottom of the dust cover to ensure.
5.Oil plug if the filter is blocked, need to check and clean up the filter; If stuck tubing, oil pump, observe the oil return oil cup, check the oil quantity to judge whether the oil pipe stuck, if stuck need to check and clean.
6. Crusher parts wear. Internal parts are wearing parts, mainly includes: fixed at the bottom of the cone at the bottom of the copper pad, eccentric sleeve copper pad and the horizontal axis sheath.
These parts are about 10 mm deep oil groove. When the groove wear to a certain extent, lubricating oil through the ability to reduce, cause high oil temperature rise. The solution:replace worn or damaged parts