Cone crusher is one of the popular medium and fine crushing equipment, suitable for crushing all kinds of medium and hard materials. Many customers feel that there is space for the improvement in capacity when using cone crusher. How to improve the output of cone crusher?
Keep the tight edge discharging port parameters unchanged.
In order to keep the output, quality and the load of production line stable, the first thing to ensure is that the tight edge discharge port parameters of cone crusher remains unchanged, otherwise it is easy to lead to the accidental increase of product particle size, and then affect the whole production line and the final output.
Try to continue the “full feeding” operation.
If a cone crusher due to feeding instability and other factors, while full load production, while half load production, then the product size, product rate and so on will also fluctuate. Half – cavity operation of the cone crusher, its products are not ideal in grading, needle and flake. Try to ensure that the cone crusher in full feeding operation, also do not overfeed, in order to get a better throughput and grain shape.
Feed not too little.
Only a small amount of raw materials will not reduce the burden of cone crusher, on the contrary, too little feeding of raw materials will not only damage the product output, the grain shape is not good, and will have a negative impact on the bearing of cone crusher.
According to the working principle of the cone crusher, the actual power of the cone crusher should not be less than 40% of the rated power. In order to obtain appropriate “load bearing positioning” and maximize productivity, the actual power of cone crusher should be maintained between 40% and 100% of the rated power, and 75% to 95% of the rated power is the best choice in operation.
The feeding point needs to be aligned with the center point of cone crusher.
Use a vertical guide plate to guide the feed drop point in the center of the cone crusher feeding port. Once the falling point is eccentric, one side of the crushing cavity is full of material and the other side is free or less material, which will cause low crusher throughput, increase of needle and flake products, and the product particle size is very large.
Ensure uniform feeding.
When feeding, it is necessary to avoid the situation that the large particle size stone is concentrated on one side and the small particle size stone is concentrated on the other side. Ensure the uniform mixing of stone.
The above aspects are the areas that need to be paid more attention to in the use of cone crusher，scientific use and scientific production, so as to obtain the maximum production efficiency.
